Recently found some electrical conduit by the dumpster where the board factories are. It was enough for 6 x pipes @ 27". Used a cut-off wheel and prepared the pipes, and while i am waiting for a !" wood boring bit and resin, i used sheet foam, cut with a razor knife, for the jigs to hold the unit in the preferred configuration… Foam isn’t very stable, but with some tape wrapped around the pipes, the unit firms up. Also, gluing the printout of the hole pattern on the foam helped. In the mean time the pipes are in the bucket which is currently filled with orgone moldings. A fully dis-assembleable CB of sorts.
Still planning to pour/gift it in the future.
This is great David, I can see a spiraling pattern with the shadow of the leaves. For me it’s a confirmation that it’s working very well. No need to use expensive cooper tubes anymore! Thank you!
